110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner   110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner

110V High quality digital ultrasonic generator 600W LED window show for ultrason. Power switch: turn on or cut off input power; ON is ON and OFF is off. If the switch is in ON position and the switch-in lamp is on, it indicates that the input power is normal. Power regulator potentiometer: small on the left and large on the right. The power can be controlled by adjusting this potentiometer.

This is optional, the general dual-frequency model or the need for 485 communication model, power regulation with adjustment and adjustment-key to complete. You don't need this accessory.
High-frequency output terminal: left is positive, right is negative, can not be reversed. If connected, there may be leakage or no output. PLC remote terminal: this terminal is optional, with two lines of output, only when two lines of the terminal are short-circuited. Power plug and power cord: connect to the power supply through the plug, and supply power to the generator. Fan: air cooling for the internal components of the generator. To ensure the reliability of the components. Product nameplate: representing the main electrical parameters of the machine, frequency, power, input voltage three parameters, note that the use conditions must be the same as the specification identified by this nameplate, otherwise the generator will be damaged. As shown, the machine model is 1500WN 40K with an input voltage of 180-265V. / I key: display switch key; can be displayed in the current, frequency, mode, address code four display interface switch; boot default display current. Trigger / stop key: only valid in timing mode. Tap this key to stop the timing while the machine is working, and then press this button to rework.

Adjust / adjust-key: on the model without adjusting knob, when the current is displayed, the /-key can adjust the current size; when the address is displayed, the address code value can be adjusted, and when the timing is displayed, the timing time can be adjusted. In mode display, three modes can be switched. That is, remote mode (divided into remote on-on-PON, remote turn-on-POFF); mode (ON); timing mode TXX. X unit for minutes, three modes of entry methods are: remote: TIME and-key press at the same time; Open: TIME and + keys are pressed at the same time; open: + and-keys are pressed at the same time. In remote mode: machine tail remote control line closed, enter remote open, control line disconnected, enter remote closing.

Dual-frequency switching: when the machine is working, the dual-frequency selection switch is pressed, and the high-frequency is output; on the contrary, the low-frequency is output. This feature is valid only above the dual-frequency model.

Frequency tracking: in the range of positive and negative 1.5KHz frequency deviation of the transducer, the generator can automatically adapt to the frequency change of the transducer without adjusting the frequency. Current stabilizing ring: The machine is equipped with a loop stabilizing circuit, and the current can be stabilized within the positive and negative 0.1A of the specified parameter, whether under the load or the water temperature and the supply voltage. It is critical for the quality stability of the cleaning product. The circuit is equipped with EMI circuit and uses phase-shift full-bridge technology to adjust power, which can minimize the interference of the generator to the outside world, compared with the traditional thyristor power regulating circuit. The severe surge current generated by the thyristor circuit when it is turned on around 90 and 270 degrees and the serious conduction and radiation disturbance derived from it can be completely solved.

The interference to PLC and other electrical appliances is minimized. You can ask for exchanging an item or refunding within 15 days from the time you received the product. If you are dissatisfied for our product and service, please tell us the reason, before you leave negative or neutral feedback, give us the opportunity to Improve, we will try our best to do it well. Thank you for your understanding. The item "110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner" is in sale since Tuesday, January 22, 2019. This item is in the category "Business & Industrial\Cleaning & Janitorial Supplies\Other Cleaning Supplies". The seller is "deruiultrasonic2012" and is located in , . This item can be shipped worldwide.
  • Modified Item: No
  • Country/Region of Manufacture: China
  • Custom Bundle: No
  • voltage and power cords: 110V/220V different plugs for your country
  • Ultrasonic power: 600W
  • MPN: Does Not Apply
  • Brand: Derui
  • Non-Domestic Product: No
  • Model: CLISON-M1
  • Transducer PC: 12
  • Power supply: 110V

110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner   110V High quality digital ultrasonic generator 1200W for ultrasonic cleaner